Is there a water pump on the monitor?
An older RV monitor panel may have a single switch for the water pump and there may be some other switches for the water pump in the bathroom or outside. There is also a water heater on and off switch at the panel. The older models are very basic. Some of the newer models make it possible to adjust the sensitivity of the RV monitor panel.
What to do when your water pump is not working?
When there is no water in the tank, they end up presuming that the pump is not working. When the water pump switch is on, it should make a noise indicating that the electricity connection is available. If the pump does not make any noise, inspect the 12-volt panel fuse to see if there is an electricity supply available.
Why are the lights on my monitor not working?
Not sure level of Lp tank but all lights are lite. Hi, Jan. This is probably not a “fuse” issue since the lights are actually working, sounds more like a monitor panel issue since all four indicators are showing full.
What does an indicator light on a water pump mean?
Pumptec is a microcomputer based pump protection device that continuously monitors motor load and power line conditions to provide protection against dry well conditions, waterlogged tanks, and abnormal line voltage conditions. Indicator lights provide complete system status, which can be easily viewed without removing the cover.
An older RV monitor panel may have a single switch for the water pump and there may be some other switches for the water pump in the bathroom or outside. There is also a water heater on and off switch at the panel. The older models are very basic. Some of the newer models make it possible to adjust the sensitivity of the RV monitor panel.
Pumptec is a microcomputer based pump protection device that continuously monitors motor load and power line conditions to provide protection against dry well conditions, waterlogged tanks, and abnormal line voltage conditions. Indicator lights provide complete system status, which can be easily viewed without removing the cover.
Not sure level of Lp tank but all lights are lite. Hi, Jan. This is probably not a “fuse” issue since the lights are actually working, sounds more like a monitor panel issue since all four indicators are showing full.
How can I check if my water pump is working?
Clean them with a light sandpaper and reconnect to see if they work. This model should have a separate switch for each tank. If it’s a stove vent model, check the main switch for power as it controls all the probes but not the water pump.
Is there a water heater on the RV monitor panel?
There is also a water heater on and off switch at the panel. The older models are very basic. Some of the newer models make it possible to adjust the sensitivity of the RV monitor panel. This comes in handy when the readings are not matching what the actual levels are.
Clean them with a light sandpaper and reconnect to see if they work. This model should have a separate switch for each tank. If it’s a stove vent model, check the main switch for power as it controls all the probes but not the water pump.
What kind of panel does a water pump have?
The older style panels were usually LVS or Ventline models and had a fuse either in line or at the distribution center. The water pump switch was usually wired directly to the pump so it would still work if the fuse blew. You can remove the panel and check for 12-volt coming into the back to verify.
There is also a water heater on and off switch at the panel. The older models are very basic. Some of the newer models make it possible to adjust the sensitivity of the RV monitor panel. This comes in handy when the readings are not matching what the actual levels are.
The older style panels were usually LVS or Ventline models and had a fuse either in line or at the distribution center. The water pump switch was usually wired directly to the pump so it would still work if the fuse blew. You can remove the panel and check for 12-volt coming into the back to verify.
